254mm 240v 1300w Ruby Halogen Heat Lamp

254mm 240v 1300w Ruby Halogen Heat Lamp

Meet the 254mm 240V 1300W Ruby Halogen Heat Lamp

We built this heat lamp for engineers who just need a compact powerhouse—something that slides right into what you already have. No fuss, no redesigns. If you’re running industrial heating, drying, or curing, and space is at a premium, this lamp brings serious, focused heat exactly where you need it.

Power, voltage, and the right fit

It runs on 240V and pulls 1300W, packing a lot of heat into a small footprint. The 254mm length is a standard industrial size, so it’s a clean swap for many existing heating setups. That power-to-size ratio is the point. You get concentrated output without spreading it out. Just keep one thing in mind: your fixture and electrical setup have to be ready for the load. Make sure your circuit and thermal management are up to the job.

What makes it work: halogen, ruby coating, and the R7s connector

The halogen cycle keeps the filament steady at high temps, which helps the lamp last longer and stay consistent in output. No surprises—just dependable heat. Then there’s the ruby coating. It filters visible light and pushes the output toward shortwave infrared. That means better absorption on many materials, and less glare in the workspace. The whole process feels cleaner and easier to control. And the R7s connector? It’s the double-ended, linear fit you see in industrial heaters. It gives you solid, two-point contact that handles high current without getting hot under pressure. Installation is straightforward. Slide it in, line up the pins, and lock it down. It’s a drop-in replacement, but double-check the pin spacing and the socket condition before you wire it up.

Where it shines—and what to watch for

Use it when you need fast, focused heat: preheating parts, drying coatings, or holding temperature in tight chambers. With 1300W, a 254mm form, and a spectrum rich in shortwave infrared, you get predictable heat with hardly any warm-up time. Here’s the trade-off, though: high intensity means you need proper ventilation and the right fixture materials. If the surrounding parts can’t shed the heat, you’ll get premature wear. When you match the lamp to the system, it just keeps running—cycle after cycle—without drama.