Technical Specifications and Implementation of the SK15 235V 1000W Halogen Infrared Lamp

September 7, 2026

Let’s talk about the SK15 235V 1000W Halogen Lamp

If you need to move a lot of heat into a material—and you need to do it now—this is the tool for the job. We designed the SK15 to blast shortwave infrared energy directly into your substrate. It doesn’t mess around with warming up the air around the part; it just pushes the energy straight in. The power side of things Running this at 235V and 1000W gives you a seriously concentrated heat footprint. We locked in that 235V spec so your wattage stays steady, even when the industrial grid is acting up. The best part? It ramps up incredibly fast. You’re hitting target temperatures in a matter of seconds. Just a heads-up: make sure your power supplies can handle that initial kick of inrush current when you flip the switch. Why halogen? (And the SK15 plug) Ever notice how some lamps get cloudy? We use a halogen cycle to stop the tungsten filament from evaporating and gunking up the quartz tube. It keeps the glass crystal clear and stops the lamp from dying early. Then there’s the SK15 connector. We went with a spring-loaded, plug-in design because nobody wants to spend their afternoon rewiring a whole heater bank. You just pop the old one out and drop a new one in. It’s a simple swap that keeps your line moving. Real-world use and a few warnings You’ll see these all over the place—PET blowing, powder coating, plastic welding. They’re great for getting heat deep into the material where you actually need it. But here is the thing: you’ve got to watch your cooling and your cleanliness. Since you’re cramming 1000W into a small quartz tube, things get hot. Fast. If your reflectors are covered in dust or oil, you’ll get hotspots. That’s a problem. If the reflector is dirty, that uneven heat can actually crack the quartz. Keep your optics spotless. Your filaments will thank you, and your equipment will last a lot longer.